Abnormal reverse temperature rise of sulfur. What causes it? Please give me some advice!
Thread Content
When the device was rotated, the temperature increases of the two thermometers in the reactor were initially the same; however, after the temperature at the upper part of route 1 rose suddenly by 20 degrees, it dropped immediately to almost the same level as the inlet temperature, with no further increase. The temperature increases in the middle and lower parts remained normal. The upper part of the catalyst is an oxygen leakage inhibitor, while the lower part is a titanium catalyst. The flow rate and pressure of the acidic gas, as well as the temperature of the sulfur production furnace, show normal temperature increases in both channels. Who experiences such a situation? Please advise!
After the temperature at the upper part of Line 1 suddenly rose by 20 degrees, it dropped immediately, ending up being roughly the same as the inlet temperature – with no further increase in temperature; this was due to a gauge failure
There’s a problem with the thermocouple; there are many such fluctuations. I also recommend checking the thermocouple