Are there any empirical rules for the installation of fixed pipe racks?
Thread Content
Regarding steam pipes, some people say that as few supports as possible should be used； My question is: are there any empirical rules that can be used as a reference, so that stress analysis can be more efficient? I would be grateful for your advice! Send flowers~~
It doesn’t say to use as few settings as possible; it only says to use reasonable settings. Piping routes vary greatly; the more you do it, the more experience you gain.
I set the brackets based on the pipe temperature, after calculating the amount of expansion! I seem to have read in some manual that the spacing between fixing frames is generally between 50-100 meters, but it’s just a manual rather than a standard; you can use it as a reference