Seeking help from experts on steam traps
Thread Content
After the hydrophobicators were installed in the workshop, pictures like this have kept appearing. Does anyone with expertise know the reason? It is mainly used in biconical vacuum dryers
The selection pressure is inappropriate; the application range of the steam trap does not match the operating pressure.
The pressure display on the nameplate indicates a recommended operating pressure of 1.0 MPa; the actual steam pressure in the system rarely exceeds 0.8 MPa
The displacement is incorrect; the displacement of the steam trap is too small.
There is a leak at the valve cover; it is necessary to verify whether the inverted bucket design meets the operational requirements
The production quality isn’t good enough; for them, the testing standards in Wenzhou don’t matter at all
The obvious quality issue with the jet at the center of the image might also be due to a problem with the selection of the appropriate model