Are there any requirements regarding the installation location of the expansion joint?
Thread Content
Is it possible to install the telescopic energy-saving device at a folded position? I don’t see any mandatory requirements regarding this. Could some teacher give me some guidance? Thank you
It depends on the type of your compensator. If it is a sleeve or axial corrugation, it must be a straight section. If they are tie rods or hinges, they are all installed at the turning points.
It is a corrugated expansion joint; may I ask which standard specifies this?
It’s not specified in the guidelines, but there are certain rules regarding how to use this compensator; it has to be used in that way, otherwise it will get damaged. You can also consult the manufacturer for specific details.