HCBBS Forum (日本語)
Submit Chemical Projects / Find Solutions
Amplify Your Requirements on a Broader Chemical Platform *Engineering · Technology · Equipment · Solutions*
Submit Request

容器の壁厚設計に関する質問です

2016-05-07View Original

Thread Content

標準式によると、16MnR鋼の最小適用範囲は6から16ですが、私の圧力容器は小さいため、計算上の板厚は3台後半となります。そこに3mmの腐食余裕を加えた設計厚さは6台後半となり、以前の適用範囲を満たしているように見えます。この計算方法は正しいでしょうか?
Reply #22016-05-07
鋼板の厚さのマイナス偏差も考慮しなければなりません
Reply #32016-05-08
この筒体の厚さは8mmにしなければなりません;楕円形のフランジの厚さは8mmとし、最小厚さは7mmと表示する。

Submit a Project

**Looking for Chemical Technology, Equipment & Solutions?** No Registration Required Broader Platform Exposure | Global Chemical Service Provider Connections

Submit Request — Free Consultation

Disclaimer

This is an automated machine translation of the original thread. Some technical terms may have inaccuracies; the original text shall prevail. Click "View Original" at the top right to access the source page, which supports IP-based automatic real-time language translation. Please watch out for contact details and sales inducements to prevent fraud. All content and translations are for reference only, representing solely the poster's personal views. For enquiries, email service@hcbbs.com.