Catalytic flue gas desulfurization – dry slag filter – statistics
Thread Content
I checked the forum, and there’s very little discussion on dry slag filters. Our dry slag filtration system isn’t effective; it uses sintered mesh made by a company in Luoyang. The suspended solids in the liquid after filtration amount to 200–600 milligrams per cubic meter, and only a few tons of dry slag can be filtered out in a month. I’d like to ask everyone about the usage of sludge filters; thank you all in advance.
Our filters can produce dry material; you can add me on WeChat at 15214382061 so we can discuss this further when we have time (*￣︶￣)
I haven’t been in contact with them. Is the water clear after filtration? If it’s clear, that means there’s less catalyst inside, which is a good thing
The bionic cyclic filtration device that we have successfully applied in petrochemical flue gas purification projects can reduce suspended solids to below 20 milligrams! Successfully applied
Could you please specify what the situation is?
At present, the candle filter is the only one that achieves good results in removing dry residue, with a moisture content that can reach 30%
For specific detailed plans, feel free to consult me; contact number: QQ418723900
We use candle filters, but the effect isn’t very good
Hermetically sealed dry slag filter; you can communicate via WeChat: 18637302991
Are dry slag filters used in catalytic flue gas desulfurization? Do you know?
There are applications, as well as cases of use for over 4 years