Continuous reforming plate exchanger feed
Thread Content
For continuous reforming heat exchangers, why is it necessary to raise the feed level to 60% within five minutes?
The minimum amount for feed processing of the device is 60%; below that, it becomes impossible to control it.
This is the minimum amount; if it is lower, the load on the device is not as high, making it difficult to operate.
The reason is that at even lower hydrogen-to-oil ratios, it becomes impossible to maintain control
1. Increasing the volume in a short period of time ensures that all parts of the heat exchanger are filled with liquid, thereby preventing deformation due to thermal expansion. Raising the flow rate to 60% represents the minimum processing volume required to ensure that the generated medium-pressure steam keeps the recycle hydrogen compressor out of the surge zone