Cyclone separator of the settler

This question is too general. There are many reasons for the lining to come off in a centrifuge, but generally it can be analyzed from the following perspectives. In terms of equipment: manufacturing defects, low standards for domestic lining installation, insufficient welding density of the mesh structure; the lining bulges or even detaches during start-up/shutdown and production fluctuations ； The selected lining material does not have sufficient strength; the formulation of the lining material, the quality of water, and the construction standards are inadequate, resulting in substandard density, strength, and surface finish of the lining ； The heating curve was not strictly followed during lining drying, resulting in insufficient lining strength. Inadequate equipment protection: exposure to water, vibrations, etc., before installation. Impact of production operations: start-up and shutdown, drastic temperature changes during normal production, and situations of operational overload. The reasons are complex and require specific analysis; the general approach is to be problem-oriented and to start by looking at the areas where there are abnormalities or changes in order to find the causes. Hope this is useful to you