Heat transfer oil furnaces often display alarms that cause the furnace to stop operating on the DCS, and manual reset is required to restart it. What methods can be used to reduce the frequency of these alarms, and which settings need to be adjusted?
Thread Content
Heat transfer oil furnaces often display alarms that cause the furnace to stop operating on the DCS, and manual reset is required to restart it. What methods can be used to reduce the frequency of these alarms, and which settings need to be adjusted?
It is really necessary to check and confirm that the fault has been resolved before performing a manual reset; otherwise, an accident may occur. Frequent police reports indicate that there may be defects in the system or improper parameter settings; each case should be handled on a case-by-case basis.
What was the specific reason for the alarm? Device failure alarm? Logical control alarm? Or report to the police for other reasons. It’s better to analyze the reasons first before eliminating the alarm.