Introduction to the usage steps of ultra-pure water equipment

Thread Content

　　First, turn on the water supply and connect the power to the chemical ultra-pure water treatment equipment, after which it can start working to produce water automatically. Second, if RO reverse osmosis water or DI deionized water is needed, simply open the corresponding ball valves on the left and right sides for water extraction. 　　Finally, once water extraction is complete, the water inlet for that area is closed, and the equipment shuts down automatically. At this point, if any water inlet is opened, the equipment starts up again automatically to produce pure water. Repeating this process, the desired pure water is produced. Note: If the pure water machine will not be used for an extended period or before leaving work, be sure to turn off its power supply and cut off the tap water supply to prevent accidents. For systems that use tap water as the water source, the inlet pressure must meet the requirements of the equipment, and the diameter of the inlet pipe must not be smaller than the specified size.