【Daily Question】Utilities - Mechanical & Electrical - 20200113
2020-01-13View Original
Thread Content
The fit system refers to a system in which holes and shafts with the same limit dimension form a fit. ( ) Answer: CorrectRelated Threads in This Forum
← Previous
- 【Daily Discussion】Public Utilities – Water Resources and Hyd
- 【Daily Question】Utilities - Mechanical & Electrical - 201907
- Is device airtightness checked before or after the three ins
- 【Daily Question】Utilities - Water Supply and Drainage - 2020
- 【Quality Version】One Question per Day 20180129 - HCBBS Forum
- 5 methods for chiseling off pile heads – which one is the mo
- 【Daily Question】Utilities - HVAC - 20200310 - HCBBS Forum
- Regarding the issue of zero wire bridging in the control cir
- 【Utility Engineering – HVAC Edition】20181214 - HCBBS Forum
- Construction begins on Rongxin Chemical’s 800,000-ton per ye
Next →
- 【Daily Question】Utilities - Mechanical & Electrical - 201911
- Installation location of current transformers in MNS cabinet
- Introduction to the Application of Pretreatment Systems in t
- 【Quality Version】One Question per Day 20171220 - HCBBS Forum
- 【Daily Discussion】Hydropower Engineering - 20200907 - HCBBS
- 【Daily Discussion】Water Resources and Hydropower Engineering
- The main structure of the PPA substation for Wengfu Chemical
- 【Utilities – Civil Engineering Version】20181114 - HCBBS Foru
- 【Daily Discussion】Hydropower Engineering - 20200903 - HCBBS
- The construction task of the electrical and instrumentation
Translated at 2026-07-23 10:22:05
Original: https://bbs.hcbbs.com/thread-2892120-1-1.html
© 2026 HCBBS Forum. Content translated for international readers.