What quality issues can occur with electronic ultra-pure water equipment?

Thread Content

　　1. The switch of the ultrapure water equipment is turned on, but the equipment does not start. This problem may occur due to faults in the electrical wiring, such as a blown fuse or loose wires. We need to check the insurance, inspect all the wiring, and check the water supply system in order to ensure the proper water pressure. 　　2. After the ultra-pure water equipment is started, the inlet solenoid valve does not open. When this happens, we need to check the wiring promptly and repair or replace the coil. 　　3. The pump rotates, but it cannot achieve the required pressure and flow rate. In such a situation, we need to rewire the connections, clean or replace the filter element, and remove air from the pump; after flushing, we then adjust the pressure. 　　4. System pressure increases, and the pump makes loud noise. We need to check the primary water pump and the pipes to see if there are any leaks. 　　5. The solenoid valve did not close after flushing. We need to check for faults in the solenoid valve control components and wiring. 　　Laytlead has adopted remote working; we are available 24/7 to answer your calls and help resolve your issues!