Thread Content
This post was last edited by hesonchang214 on 2020-3-21 at 17:49. Installation of industrial pure water production equipment – incorrect installation of components. Industrial pure water production equipment is composed of various components, and this issue arises when some of these components are installed in the wrong manner. Therefore, it is important to pay attention to the installation process and to follow the instructions in the manual strictly. Users usually cannot install it by themselves; they need to hire professional staff to carry out the task, and it is essential to follow each step carefully to ensure that there are no leaks in future use. Installation of industrial pure water production equipment – The rubber ring on the filter housing is not properly installed. The filter housing in industrial pure water production equipment is made of plastic; if leakage occurs, it is necessary to check whether the internal component, namely the flexible rubber ring, is functioning properly to provide a secure fit. If the washer on the filter housing is not installed properly, is in the wrong position, or is not secured tightly, leakage may occur. At this point, the rubber ring can be found and attached to the filter housing interface, after which the filter housing is installed; usually, the leakage problem is resolved. Installation of industrial pure water production equipment – improper connection of pipes. The pipes in industrial pure water production equipment are used to transport water; when connecting the internal filters, quick connectors are typically used for this purpose. If leakage occurs, it is possible to check whether the connection between the pipe and the connector is tight enough. If the end of the pipe is not smooth, it can be trimmed off and then connected to the fitting; pulling it a few more times will help prevent leaks.