【Daily Question】Chemical Analysis Version, 2019.8.11
Thread Content
This post was last edited by zjp on 2019-8-11 07:38. Multiple-choice question: Identify the standard procedure among the following titration analysis operations. ( ) A. Before titration, rinse the burette three times with the standard solution to be used. B. During titration, shaking the conical flask causes a small amount of solution to spill out. C. Before titration, the conical flask should be rinsed three times with the solution to be analyzed. D. If the solution in the burette is not at 1 cm below the zero mark, use a dropper to add solution until the lowest point of the meniscus is in contact with the “0” mark. A
Before titration, rinse the burette three times with the standard solution to be used
A. Before titration, rinse the burette three times with the standard solution to be used