Electronic balance

To change the calibration weights of an electronic balance, you need to follow the balance’s instructions. Typically, these steps include: 1. **Entering correction mode**: This is usually done by holding down a specific key or key combination. 2. **Place the weights**: If you want to use weights of a different weight (such as 100 grams), first ensure that the balance is clean and level, then place the 100-gram weight. 3. **Perform calibration**: Follow the on-screen instructions; the balance will read the weight of the weights and carry out calibration. 4. **Save Corrections**: After completing the corrections, save the settings as instructed to exit correction mode. If the balance only supports calibration with 50-gram weights, and you need to use weights of other weights for calibration, it may be necessary to contact the manufacturer to confirm whether this is possible or if there is a specific calibration procedure. Some balances may be fixed to use specific weights of weights for calibration and cannot be changed. .

In this case, one can only follow the instructions in the user manual; the procedures vary from manufacturer to manufacturer

Sartorius and Mettler seem to be different