Thread Content
What is the operation process of the Delit auto-ignition point tester? Operation procedure for the Delit auto-ignition point tester: 1. After unboxing the auto-ignition point tester, carefully remove the packaging, check the accessories against the packing list to ensure there are no damages, and place the instrument steadily on the workbench. 2. Connect the auto-ignition point tester to a ground wire to ensure safety. 3. Insert the power plug with a properly connected ground wire into the corresponding socket. 4. Place the sample in the heating chamber, connect the power cable, and press the power switch; then the three sets of heaters in the heating chamber begin to regulate the temperature. The testing procedure follows the methods specified in the national standards. Operation of the temperature controller: 1. Press the SET button for 3 seconds to enter the PID parameter adjustment menu. Press the SET key to select the parameter you wish to modify; press the AT key briefly, and the digital display will flash, allowing for shifting. Use ▲/▼ to change the data, then press SET to confirm. To scroll down, keep pressing the SET key. While in the setting modification mode, if no action is taken within 25 seconds, it will automatically return to the measurement mode; alternatively, pressing SET for 3 seconds will also allow exiting and returning to the measurement mode. 2. The auto-ignition point tester automatically enters temperature control mode; once the temperature reaches the set value, the test can be conducted. For specific test procedures, refer to the detailed test guidelines