SKF bearing model issues
Thread Content
Dear all**, when ordering spare parts for centrifugal pumps, I noticed that there are two types of SKF bearings 3205 in the system: 3205 and 3205-2RS1. I checked online and it didn’t mention any differences; please **give me some advice!**
The text was written incorrectly; it should be 6305 and 6305-2RS1:L
Check the mechanical design manual; almost every letter in it represents a certain meaning.
2RS1 represents； Nitrile rubber contact seal with steel frames on both sides of the bearing
**Could you send a table of bearing letter codes? :handshake
There should be rubber seals on both sides of the bearing; whether these are necessary depends on your operating environment. If it’s for a centrifugal pump’s bearing housing, I don’t think they’re needed
:handshake thank you
Could you send a comparison table? My brother has just started learning
It’s the one used on centrifugal pump bearing housings: handshake