How to install the rotating ring of a mechanical seal
Thread Content
This post was last edited by fov_moshoucs on 2018-1-7 at 09:03. The link is http://imgsrc.baidu.com/forum/pic/item/b65c5143fbf2b21161e570a4c18065380ed78ef2.jpg. Is it such that the spring seat compresses the spring, with the protruding part of the moving ring fitting into the recess in the spring seat, and then the hex key is used to tighten the spring seat?
The amount of compression should be determined based on the measurement results
It’s not just a matter of pressing down to tighten the screws; the degree of compression needs to be determined based on the circumstances. Spring boxes of this type cause the springs to compress to a relatively large extent
The compression amount can be considered to be 40~45% of the spring’s full compression amount~~~~