blower
Thread Content
Do we have any blowers that can extract steam, with a flow rate of around 300,000, and a slightly higher air pressure?
If so, how to address the issues of water hammer and high vibration?
This post was last edited by tanxjzm on 2018-8-6 at 10:13. For simple drainage, a jet drainer can be considered; if air pressure is a factor, perhaps MVR?
The screw pump can be used, but the air volume per unit machine cannot reach such a high level
Are there any good suggestions regarding the selection of drainage devices, or is it possible to calculate the flow rate required for drainage? Thank you
This air volume isn’t difficult; has the required static pressure been calculated? There are specific parameters; you can take a look at our solution.