Are there any regulations regarding the standards for submerging rolling bearings in oil tanks, as well as the oil level height in such tanks? Need help from experts! ! !
Thread Content
We have two centrifugal water pumps; the oil window openings are positioned too low. Too much oil leads to oil spillage, while too little oil causes bearing damage. I wonder if there are similar standards. ? ? ?
The lowest ball in the rolling bearing should be submerged in oil to a depth of 1/2 to 1/3 of its height
The height can be adjusted using a constant-level oil gauge
1/2 of the lowest ball in the rolling bearing
This is mainly related to the pump’s speed.
1/2 of the lowest ball in the rolling bearing