Questions about sliding bearings
2019-08-17View Original
Thread Content
Could some expert explain what this 35-degree angle represents?Related Threads in This Forum
← Previous
- 【Mechanical Equipment Technology Exchange Edition】Mechanical
- No-load test run of centrifugal compressor - HCBBS Forum
- What should be noted during the maintenance of multi-stage c
- Hollow spiral vacuum continuous dryer - HCBBS Forum
- Regarding piston ring clearance - HCBBS Forum
- Pump outlet line pressure gauge - HCBBS Forum
- Answers to Guess the Device by Looking at the Picture 201709
- Installation of the level gauge float - HCBBS Forum
- Special equipment inspection - HCBBS Forum
- Guys. Please - HCBBS Forum
Next →
- Which expert has a schematic diagram of the hydraulic nut at
- What are the required standards for the moisture content ins
- What is the purpose of the cross-line from the shaft seal st
- Coupling problem - HCBBS Forum
- In which fields can fully automatic self-cleaning filters be
- What are the laws, regulations, standards, and specification
- Consult about high-speed reduction gears - HCBBS Forum
- The stirring shaft of a frame-type mixer has broken – how to
- Turbine - HCBBS Forum
- Variable diameter at pump inlet and outlet - HCBBS Forum
Translated at 2026-07-21 03:10:14
Original: https://bbs.hcbbs.com/thread-2766901-1-1.html
© 2026 HCBBS Forum. Content translated for international readers.