As shown in the picture
2020-01-01View Original
Thread Content
It's a spare part, I can't figure it out! Ask for advice!Reply #22020-01-03
Generally speaking, the valve is a one-way valve
Related Threads in This Forum
← Previous
- Edwards Chemical Dry Vacuum Pump Maintenance Manual - HCBBS
- Is the reverse circulation line of the canned pump installed
- Look at the quality of this construction - HCBBS Forum
- Common operating problems and solutions for propylene compre
- Machining of pin holes - HCBBS Forum
- 【History of Haichuan Chemical】Dalian Refrigerator Factory –
- There is information regarding compressors - HCBBS Forum
- Refrigeration equipment - HCBBS Forum
- Technology - HCBBS Forum
- Material selection considerations for hydrogen chloride comp
Next →
- Design of bearing housing and bearing fit - HCBBS Forum
- Steam turbine problems - HCBBS Forum
- For a two-stage pusher centrifuge, what is the thickness of
- Where does the shaft seal air for this back-pressure steam t
- I would like to ask why a gap of 0.1–0.25 is required betwee
- Is it difficult to write a maintenance plan? - HCBBS Forum
- 【Mechanical Equipment Technology Exchange Edition】Mechanical
- This post can be deleted, thank you - HCBBS Forum
- Alarm for high vibration levels on the non-driving side of t
- How to lubricate a vertical cycloidal pinwheel reducer? - HC
Translated at 2026-07-26 11:11:15
Original: https://bbs.hcbbs.com/thread-2879196-1-1.html
© 2026 HCBBS Forum. Content translated for international readers.