Tile backing force
Thread Content
As shown in the picture, isn't this the tile back-tightening force? How could it be the tile gap? The pad gap is the gap between the bearing pad and the shaft. Using the shaft lifting method, two dial indicators can be used to drill it out, or a feeler gauge can be inserted directly. Let the experts discuss it
Imagine that lead wire b is d. If lead wire 1 is installed in a state where it is greater than or less than d, what will happen? For some rotors, the top clearance of the shaft cannot be measured after installation. If d is large, the bearing bush cannot be effectively pressed. If d is small, the top clearance of the top bush is too small, or the main shaft is locked by pressing. Whether it is related to this factor, for reference. It is recommended to follow the data installation specified in the device installation instructions.
From the picture, it should indeed be the tile back-tightening force. The tile back-tightening force should be reflected by the gap value. Otherwise, the magnitude of this force will not be really measured.