Installation of another centrifugal compressor
Thread Content
I’m sharing the installation process of another centrifugal compressor, outlining a few key steps as well for everyone to discuss and learn from. The high-pressure cylinder of this compressor features a vertically split structure, and it will not be disassembled on-site; the low-pressure cylinder, which has a horizontally split design, was disassembled on-site. At present, the unit has not yet undergone oil circulation or individual testing, so the shaft end seals shown in the photos are still trial seals – they will be replaced with proper dry gas seals and carbon ring seals after the individual testing is completed.
I will share the installation process of the centrifugal compressor. The notable feature of this installation is that the high-pressure cylinder uses a vertically split structure, while the low-pressure cylinder adopts a horizontally split design and is disassembled on-site. At present, the compressor has not yet undergone oil circulation or individual unit testing; temporary testing seals are being used for the shaft end seals. Once the single-unit trial run is completed, it will be replaced with official dry gas seals and carbon ring seals. I hope this process will be helpful to everyone. .
Is this alignment table frame homemade or provided by the manufacturer?
Is it a carbon dioxide compression unit? It’s electrically driven – which company manufactures the motor and gearbox?
Motor: Wolong Nanyang; Gearbox: SHENGU