Calculation of pressure vessel nozzle diameter.
Thread Content
I have a question for everyone: how is the diameter of various connections on the deaeration tower calculated? Can you give me a calculation software? Thank you so much.
I have never worked on deaeration towers before, but according to the regulations for pressure equipment, SW6 can be used to check the strength of the pipes. As for the specific diameter, it is necessary to take into account the requirements for material inflow and outflow, which are related to the process aspects.
This should be a problem related to process calculation, which needs to be done based on the requirements for inlet and outlet flow rates.
Could you explain the calculation method in detail? Or is there any software that can calculate it?
The process design manual contains the calculations for the deaerator
Determine the pipe diameter based on your flow rate