I have a few questions regarding the use of PVelite software; please give me some guidance!
Thread Content
When calculating the lugs at the tail end of the tower, a warning appears: “Warning: The Tailing lug load is 0. Please make sure that you have entered Lug locations on the Loads Tab -> Installation | Miscellaneous Options.” I found the section shown in the image below, but I don’t know how to fill it in. I would be extremely grateful if anyone who knows how to do this could give me some guidance!
How should I fill in the concrete data for the skirt base in this diagram? ? ? ?
This post was last edited by lucyghb on 2019-8-29 09:45. When calculating the pipe outlet, how should the values within the red line in the image be filled in? I would be extremely grateful if any friends who are aware of the answers to these questions could offer some guidance. Thank you so much!
The distances between the lifting lugs – those two values are different; you entered 100 for both. You need to understand what that means before entering the data again.
Learn PV, add WeChat zgmhhs
By default, this data is used to restrict reinforcement and similar processes.
By default, if the owner provides it, it can be entered according to the owner’s requirements
For the location of the lifting lugs, press F1 for instructions