Has anyone done any welding evaluation on end-joint welds of thin steel plates with a thickness of about 1 mm?
Thread Content
If it has been done, according to what standard it was done? Is it autogenous welding or filler wire welding?
Self-fluxing welding is possible, but what makes it qualified?
What is the difference between soft and hard stainless steel plates?
This thickness is generally not filled with wire and is directly self-fusing. What I am curious about is, is the 1mm thickness used for pressure-bearing equipment? The strength is enough, but the stiffness is not enough, right?
Welding plate and tubes of plate heat exchangers and plate and shell heat exchangers.