Where can I find the standard dimensions and technical parameters of the reactor?
Thread Content
I have been doing my graduation project recently, and when it comes to equipment selection, where should I go to find the models and technical parameters of the relevant chemical equipment? As shown in the picture, the volume of the reaction material I calculated is 10057.14L. So should I choose a 15000 or 20000L reactor? Besides, I don’t know if there is a reactor with a capacity of 15000L. Where can I find the standard volume and parameters of the reactor? Save the child! Many thanks!
Reactors are all customized equipment. There is almost no so-called standard volume and parameters. They must be determined according to your material characteristics, type of agitator, stirring speed, etc. You can have 15,000, 14,000, 13,000, or 12,000. Let me give you a table to look at. It is based on a certain standard and is for reference only. It is of little significance.
You can choose this one first, with a diameter of 2300mm, a cylinder height of 2800-3000mm, and a volume of the lower head of about 1760L. The volume of the cylinder part is 11600L.
thank you! So that’s it, I chose the 15000L one, I thought the teacher wouldn’t look at it carefully orz
The current nominal volume divided by the filling factor is the final full volume. Then take the height-to-diameter ratio, calculate the size, and check the heat exchange area for heat exchange. If the heat exchange is not enough, continue to adjust...
Some customers need a short and fat type, and some need a slender type. We cannot generalize.
What a complicated guy. . After all, I am just simulating the design, not actually putting it into production. As for the dimensions, I only count the input amount of reactants, select the capacity of the equipment, and other parameters are written according to what I found on the Internet, but thank you for your answer!
Okay, actually I am just doing a graduation project... There are not so many requirements, as long as it meets the process design and can hold the amount of materials, it will be fine.