Waste heat and exhaust gas recovery project
Thread Content
Our company has waste heat steam from condensate at 100 degrees Celsius, with a pressure of approximately 0.1 MPA. The flow rate has not been measured; it is approximately 2 tons per hour. Now, we wish to recover and reuse this steam (producing steam at 0.4–0.5 MPA and 150 degrees Celsius). We have considered using steam ejectors; however, since the pressure of steam available on site is only 0.9 MPA, the ejectors consume a large amount of such steam, resulting in poor performance. The steam-based temperature and pressure booster was examined; its initial investment is too high, and it consumes a lot of electrical energy (a 90KW motor with an initial investment of 150W). There is also a steam compressor, and we are still considering it. I would like to ask if any experts have better suggestions, or if there are any companies that can meet the requirements – please feel free to get in touch!
Those with good suggestions can contact me via WeChat at daiyu595
I’m also curious about this issue: the use of low-quality energy sources. If possible, if there is a rough plan, we can discuss it here.
Our company’s waste steam pressure-boosting steam recovery system can achieve this; phone number: 18795830275
I’ll call you after the holiday. What’s your company name?
Our units also have it; air cooling is used