Welding engineer
2022-08-15View Original
Thread Content
This post was last edited by chenjdvip on 2022-8-27 14:57 by a welding engineerRelated Threads in This Forum
← Previous
- If the design temperature of the container is above room tem
- Learn from Images *Heating Furnace - HCBBS Forum
- Design temperature: -110, material: S30408 - HCBBS Forum
- Calculation of the cone bottom angle in a cone-bottom sedime
- Heat exchanger operating temperature - HCBBS Forum
- The “three major problems” in welding high-strength weatheri
- Different understandings of the scope and categories of tole
- Valve for mixed hydrochloric acid and sulfuric acid solution
- Heat exchanger shell side anti-scour plate - HCBBS Forum
- API calculation table - HCBBS Forum
Next →
- Causes of corrosion in air cooler tube bundles and protectiv
- Is there any standard that specifies the required number of
- I would like to ask for advice - HCBBS Forum
- Effect of alloying elements in welding wires on weldability
- Methods and catalysts for increasing the specific heat of va
- Welding materials - HCBBS Forum
- Flow pattern of the stirrer - HCBBS Forum
- Given the inlet and outlet temperatures and flow rates of wa
- The cyclone separator cannot be cleaned and has dead corners
- Boiler water level control - HCBBS Forum
Translated at 2026-07-23 17:11:43
Original: https://bbs.hcbbs.com/thread-3458739-1-1.html
© 2026 HCBBS Forum. Content translated for international readers.