Equipment and Vehicle Turning Over Management System

Thread Content

I. Standards for rotating equipment and preparing machines for operation 1. The management systems for rotating the rotating equipment in various workshops must be detailed, specific, and practical to implement, and they should also include mechanisms for rewards and penalties. 2. The turning of rotating equipment must be carried out carefully, and the records of routine inspections must be accurate. There are specified intervals for turning each type of rotating equipment; the records of such turning operations must be filled out carefully, with appropriate markings made. 3. If any signs of leakage such as oil seepage, oil leakage, or air leakage are detected during the turning of the machine, they must be addressed promptly. When it is found that the equipment is not ready for use, emergency repairs must be organized promptly. Relevant personnel from the control room, the Production Technology Department, and the Production Technology Department (Maintenance Workshop) must be on site to coordinate and work together with the workshop to resolve the issue until the equipment is back in working condition. 4. Daily management of rotating equipment rotation 4.1 The workshop requires the teams to carry out equipment rotation in accordance with the relevant management regulations, and to keep records. Any issues that arise during the rotation process must be addressed promptly to ensure that the equipment remains in good condition. 4.2 The engineer in charge of the relevant area in the maintenance workshop must conduct on-site inspections at least once a day; any issues identified during these inspections should be promptly reported to the workshop for handling, and the results of such handling must be verified. 4.3 Workshop supervisors and technicians should stay close to the site at all times to monitor the operation of equipment there as well as the status of vehicle preparation and rotation. Technicians shall conduct on-site inspections no less than twice a day, and promptly arrange for personnel to address any issues identified. II. Assessment Provisions 1. The Production Technology Department will periodically organize relevant departments and workshops to conduct inspections on the management of rotating standby vehicles. Penalties are imposed on workshops that perform poorly. 2. A fine of 200 yuan shall be imposed on the workshop responsible for any issues that arise with the equipment reserved for use, due to poor management of the rotation of such equipment ； If the Production Technology Department and relevant departments discover that gear turning is not carried out as required during inspections, a fine of 5 yuan will be imposed on the workshop where each rotating device is located. 3. Plants that are able to promptly eliminate potential system hazards identified during the turning-over process, thereby avoiding shutdowns or reduced production, will be commended and rewarded. Workshops that cause accidents or lead to system shutdowns or reduced operations due to failure to perform wheel turning (failing to detect problems with the equipment in a timely manner) will have their supervisory managers held accountable, and they will be fined between 100 and 500 yuan.