How to look up ASME standards?
2018-10-26View Original
Thread Content
What is the outer diameter of the N7 manhole? ? ?Reply #22018-10-26
According to the standards, flange 616, outer diameter of the pipe fitting 610
Related Threads in This Forum
← Previous
- distillation - HCBBS Forum
- Does a short circuit between a pressure vessel and a safety
- Heat treatment of equipment subjected to H2S stress corrosio
- Seeking advice on heat exchanger design and material selecti
- Equipment and Vehicle Turning Over Management System - HCBBS
- Liquid chlorine storage tank - HCBBS Forum
- Summary of Technical Requirements for Pressure Vessels (16)
- 【Daily Question】【AC Version for Static Equipment...Question
- Basic Knowledge of Chemical Equipment Operation - HCBBS Foru
- Is the sampling port of the storage tank located on the oval
Next →
- Sample Questions for the 2023 Simulation Exam on Safety Mana
- Questions regarding non-destructive testing - HCBBS Forum
- Animations simulating the operation of various mechanical an
- Rainproof, integrated explosion-proof ultraviolet flame dete
- Do the burners of a boiler require maintenance by profession
- How to select wear-resistant elbows - HCBBS Forum
- Calculation of the thickness of the flat cover with openings
- Pulite Company teaches you how to choose the grade of U-bolt
- Do valves with a pressure below 4.0 MPa not require a manufa
- I would appreciate it if the experts could give some advice.
Translated at 2026-07-21 03:01:32
Original: https://bbs.hcbbs.com/thread-2118641-1-1.html
© 2026 HCBBS Forum. Content translated for international readers.