Inspection regulations for safety valves of fixed pressure vessels
Thread Content
A pressure vessel is equipped with 6 safety valves of the same specification, 5 in use and 1 as a spare. When these safety valves are inspected annually, is it possible to remove 3 of them at a time for inspection?
No. According to the regulations, safety valves must all be in proper working condition; it is not sufficient to test only some of them. All safety valves need to be inspected during annual checks to ensure their safety. .
In my opinion, if so many settings are provided, it is surely to meet the requirements regarding safe discharge volumes; the safety valves on the equipment should all be calibrated in accordance with the specified standards
One principle is that, during online verification, it must be ensured that the total discharge capacity of the remaining safety valves meets the requirements for safe discharge. Or shut down for verification.
It should be possible; conduct the tests in two stages to ensure a certain level of emissions
You can hire a qualified online inspection company to conduct the inspection.
Normally, all safety valves on the equipment are in use; when it’s time for the next inspection, the spare safety valves are deactivated, as they are designed to be taken out of service for inspection purposes. After passing the inspection, verify the other 5 safety valves one by one; once all of them have been checked, they can be put into use. This is safer.