Aspen simulation of mixed solution properties
Thread Content
This post was last edited by liudi0317 on 2017-1-16 at 15:26. I want to set the concentration as a variable in order to see how the temperature changes; how should I do this?
When the operating variable is basis-Frac or basis-Flow, a component must be specified. Two of temperature, pressure, steam fraction, or duty cycle must be specified as control variables, parameter variables, or fixed-state variables. This is a hint for me, but I can’t figure out where to get it
The second graph was created by me; it shows a mixture of 0.3 of sodium nitrate, 0.3 of potassium nitrate, and 0.4 of water. The variable here is the amount of water, ranging from 0 to 1. I don’t understand how the mass percentage of water changes – so how do potassium nitrate and sodium nitrate change then?