How can Aspen EDR simulate shell-and-tube heat exchangers?
Thread Content
How can Aspen EDR simulate shell-and-tube heat exchangers? Please provide guidance
Choose double pipe
Where is this setting? In the tubes?
It’s the place where you set the management structure; in the BEM type, it’s type E. By scrolling down, you’ll see type D
But could EDR have a minimum requirement for the shell diameter? It seems that the calculated heat exchange area of the coil is quite large
But could EDR have a minimum requirement for the shell diameter? It seems that the calculated heat exchange area of the coil is quite large
This post was last edited by Aichibaozi de Xiaomantou on 2020-2-27 09:01. Hmm
The original poster mentioned that the maximum outer diameter of the tubes in the shell-and-tube heat exchanger is 0.2 meters. I want to use the double-pipe model to simulate heat exchange in a jacketed reactor; can a value of 0.2 meters be entered? How can this issue be resolved?