What to do when the elbow angle exceeds a certain value
Thread Content
An error was found during the inspection after modeling – how to fix it? 2 ERROR 5E 10-20: The bend angle of element 10 to 20 is 114.62 Deg; it must be between 5.00 and 95.00 Deg.
This requires modifying the piping; generally, two bends of less than 90 degrees are used to replace this bend. In reality, such elbows are not available for purchase either; usually, two elbows are used to connect together.
Thank you; it seems that it can be adjusted to 135 degrees in the settings, but not beyond that.
The angle of a single elbow should not exceed 95 degrees; otherwise, two elbows need to be used together