During CARSARⅡ modeling, the error \"The elbow length is insufficient; it does not match the curvature of this elbow\" appears”
Thread Content
I would like to ask about an issue I encountered while modeling: \"The elbow length is insufficient; it does not match the curvature of this elbow.\" I tried adjusting it for a long time but with no success. How can this be solved? Thank you!
In the configuration, modify the bending angle, or manually adjust the elbow curvature
The straight pipe section where the elbow is to be installed is too short; the minimum length of the straight pipe section should be greater than the radius of the elbow. What did you adjust for such a long time?