HTRI error report please ask
Thread Content
According to the physical properties of the heat exchanger data table, enter various parameters and run the software. The error is reported as: Reference temperature (hot,ibar 1): not enough valid temperature points remain to use the profile. Ignore profile input. Run Failed is explained as: Reference temperature (hot, ibar 1): There are not enough valid temperature points to use this profile. Profile input is ignored. The operation failed, but I actually entered the temperature data of four points, which has met the requirements of at least three temperature points. Please give me some advice. Thank you very much!
Interpolate a few more points forward and backward to see if your reference temperature exceeds the limit.
I also encountered this problem today.~
If you can upload the original document, we can discuss it together. It's difficult to understand the full picture from just one error message.
What does ibar1 mean? ?