【Process Engineering Division – Chemical Engineering Software Forum – Daily Question – Questions 03-14】
Thread Content
This post was last edited by Yunmu on 2019-3-14 07:59. [Process Engineering Section – Chemical Engineering Software Discussion Forum – Daily Question – Question 03-14] In AutoCAD, which of the following is a characteristic of axonometric drawings? ( ) Multiple-choice question: A. Lines that are parallel to each other in the solid remain parallel in the axonometric drawing. B. Circles in the solid are still represented as circles in the axonometric drawing. C. Diagonal angles in the solid are still drawn at their original angles. D. The dimensions shown in the axonometric drawing correspond to the actual dimensions of the solid. 1
A. Lines that are parallel in reality remain parallel in the axonometric diagram as well
A. Lines that are parallel in reality remain parallel in the axonometric diagram as well
A. Lines that are parallel in reality remain parallel in the axonometric diagram as well