[Process Engineering Division – Chemical Engineering Software Forum – Daily Question – Questions 04-08]
Thread Content
This post was last edited by Yunmu on 2019-4-8 at 11:05. [Process Engineering Section – Chemical Engineering Software Discussion Forum – Daily Question – Questions 04-08] In AutoCAD, when the \"Intersection\" capture mode is used, it is possible to capture intersections of ( ) – multiple options are allowed. (A) Arcs, circles, ellipses, elliptical arcs, lines, polylines, polygons, rays, splines, or construction lines, among other objects. (B) Can capture the edges of a face region. (C) Can capture the edges of curves. Note: Questions are valid only for that day (3 correct answers, 1 wrong answer; posts filled with irrelevant content will be deleted). Responding to previous posts on a large scale is considered spamming, and such responses will not earn any points or may be scored at the discretion of the organizers. =123
In AutoCAD, when the \"Intersection\" snap mode is active, it is possible to capture intersections (ABC) among various objects such as (A) arcs, circles, ellipses, elliptical arcs, lines, polylines, polygons, rays, splines, or construction lines. (B) Can capture the edges of a polygonal area. (C) Can capture the edges of curves. Note: Questions are valid only for that day (3 correct answers, 1 wrong answer; posts filled with irrelevant content will be deleted). Repeatedly posting in previous threads is considered spamming, and such posts will not earn any points or may receive points at the discretion of the organizers.