Dynamically simulate the display problem of stripchart
Thread Content
This post was last edited by Higee on 2019-4-13 00:40 Dear friends, I recently encountered a headache problem, the details are as follows: Hysys dynamic simulation, the dynamic changes of parameters can be seen in stripchart during operation. However, after the operation stops and the timeline of stripchart is adjusted to the entire running time, the graph only displays the last approximately 100 minutes of graphs. The previous time period is blank and nothing. The same is true for viewing historical data. I have tried several different hysys versions and all have this problem. It seems that the data storage is limited, and the later data will wash out the previous ones, but this should not be the case intuitively. Is there something wrong with the setting? Please give some advice from experienced friends. Thank you.
Has anyone encountered this problem? :(
You can change the interval and number of points through settings. You can change it as much as you want. I usually take 100,000 points and 1 point per second, which is more than a day. However, because of the large amount of data stored, the model will become very large.