I hope an expert can explain why there is a gap between the cylinder and the gasket during modeling! !
Thread Content
Where D is the diameter of the cylinder, t3 is the thickness of the gasket, Ax is the height of the gasket, A0 is the arc length of the gasket; the coordinate origin is (0,0,0), with the center of the lower weld on the cylinder being at this coordinate origin, and 50 represents the distance from the lower weld on the cylinder
This is from the PDSOFT software
What software is this? Could you share it?
This software can be downloaded from the Internet, but most importantly, an electronic dog needs to be purchased
Rank in this version: 100+; Popularity in this version: 15. Popularity score: HaiChuan Primary School, Grade 6 – 150 points, 395 posts, 2 topics. UID: 704203. 5th floor. Poster | Posted 1 second ago | View only this author’s posts. This software can be downloaded from the Internet; what’s most important is that an electronic dog needs to be purchased