Seek advice on the settings for different filler sections in the Radfrac module
Thread Content
As shown in the figure, I would like to use packing of different sizes in the distillation column: 16 mm Pall rings above the feed point and 38 mm Pall rings below it. There are 10 theoretical plates in total. Is it possible to set this up in the Radfrac module? Is it still necessary to divide it into two towers for calculation? Thank you all!
I’ve never tried using two types of packing in the same tower; it might be possible to use two separate towers, with no reboiler in the upper tower and no condenser in the lower one.
Okay, thank you! I asked Teacher tdl522, and he said it can be set up this way.