Stress cannot be calculated during structural modeling calculations
Thread Content
Hello everyone. I am learning structural modeling in CAESAR – not pipeline modeling. Since I need to design the steel structures that serve as supports for brackets, I need to verify the strength of these structures; therefore, I decided to use CAESAR for this purpose. After creating the model, I was able to calculate displacements, but stress values were not displayed, with the message “No code-based stress check performed”. I would appreciate it if experts could help me figure out what might be the problem. Thank you
Hello, OP! I am studying *Z. I would like to ask how to import steel structures into piping systems – what are the procedures for doing this? Thank you
Caesar’s steel structure modules can only take stiffness into account; stress cannot be evaluated. If performing checks on supports and hangers, it is recommended to use structural software such as PKPM or STAAD.