The process operates differently; there’s a problem with the cyclone separator, and it’s difficult to understand the behavior of the solid particles
Thread Content
->Processing input specifications ... *** SEVERE ERROR IN THE “BLOCK” PARAGRAPH WHICH BEGINS ON LINE 99 BLOCK NAME: B7 MODEL NAME: CYCLONE SUBSTREAM ATTRIBUTE TYPE: “PSD” MUST BE PRESENT IN ALL MATERIAL STREAMS FOR THIS BLOCK. IT DOES NOT APPEAR IN STREAM: “CAOH2-1”. PROCESSING FOR THIS BLOCK WILL NOT CONTINUE. *** SEVERE ERROR BLOCK: “B7” APPEARS IN THE FLOWSHEET, BUT NO BLOCK PARAGRAPH HAS BEEN ENTERED FOR IT. ! Errors while processing input specifications
According to the error message, the problem lies in the cyclone separator section. The error message indicates that no attribute of type “PSD” was found in the material stream “CAOH2-1”, so it is not possible to proceed with processing this cyclone separator. At the same time, it is also indicated that no relevant block parameters have been entered for the cyclone separator. Based on this information, it is necessary to check whether the correct attribute types are included in the input material flow, and to ensure that the parameters of the cyclone separator are properly defined in the input. .
Search for information on the definition of solids, and set the PSD and solid composition
Have you resolved it? I’ve encountered a problem too; could you advise me on how to solve it?