High-concentration gas Aspen input

First, it is necessary to establish a gas-phase component and select the appropriate property model. In the Aspen Plus software, a new gas-phase component can be created, with the mole fraction of acetic acid set to 100%. Then, add a feed device to the flowchart; in the parameter settings of this device, select \"mole fraction of components\" as the feed data type, and set the mole fraction of acetic acid to 1. Next, add a reactor unit to the flow diagram to treat acetic acid waste gas. In the reactor parameter settings, select the appropriate reaction model and specify the reaction conditions, reaction rate, etc. Finally, other necessary unit operations such as separators and washers can be added to treat acetic acid waste gas. Depending on the specific circumstances and objectives, different unit operations can be added as needed. Throughout the process, please pay attention to selecting appropriate material property models and condition settings to ensure the accuracy of the results. .