How to verify the local stresses at the nozzles and shell resulting from calculations? I hope someone who understands this or an expert can give some guidance. Thank you.
Thread Content
As titled: If the thrust and torque values of the medium at the process pipe outlet are given, how can the local stresses in the pipe outlet fittings and the shell be checked and calculated? I hope someone who understands this or an expert can give some guidance. Thank you.
There are local stress calculations for the components of SW6
Well, SW6 can be used to calculate local stress, but generally three sets of data are required for such calculations. However, the problem only provides the thrust and torque exerted by the pipeline medium – so how can these be converted into three sets of data?