【Mechanical Equipment Technology Edition】Daily Question 201801020 – Brain-teasing Quizzes with High Scores as Rewards (7.3)
Thread Content
This post was last edited by YORK Industrial Refrigeration on 2018-1-22 at 08:13. Starting from now, in order to enhance communication among users, a 【Daily Question】 activity has been launched on the Mechanical Equipment Technology forum. We hope everyone will participate actively to progress and improve together! ! ! Rewards: 3 wealth points for active participation, 20 wealth points for correct answers. Those who mark the positions will be rewarded with 20 HaiChuan coins. This question is valid for two days; no score will be given after that time (as shown in the image below). This refers to the side opposite the inlet and outlet sides of the condenser of the York chiller. Hint 1: The end face in the image is divided in half by a partition in the end cover (as can be seen from the gasket). Hint 2: The inlet and outlet ends are on one side. Hint 3: The front and back end faces of the heat exchanger are identical, but the positions of the partitions in the end cover differ. How many flow paths does this heat exchanger have? Those who are careful enough can mark the positions of the partitions for the inlet and outlet sides on the end face diagram. https://attach01.hcbbs.com/forum/201706/15/193603y2h4hh4xunph1txz.jpg ============================== High-quality promotions: Mechanical equipment——Maintenance procedures for York screw compressors https://bbs.hcbbs.com/thread-1806833-1-1.html Mechanical equipment——Upgrading of York Quinton control centers https://bbs.hcbbs.com/thread-1804837-1-1.html Mechanical equipment——Major repairs for GEA Grazer screw compressors https://bbs.hcbbs.com/thread-1800467-1-1.html Mechanical equipment——Disassembly and maintenance of British HOWDEN screw compressors https://bbs.hcbbs.com/thread-1832529-1-1.html Mechanical equipment——Disassembly and maintenance of Japanese Maekawa MYCOM screw compressors https://bbs.hcbbs.com/forum.php?mod=viewthread&tid=
It’s not drawn correctly; give it another try. Think about how you will seal the partition you’re making
Since the image does not show all the end faces, it is estimated based on the current image that there are 4 round trips; the schematic is attached. I am not an expert in this field of equipment, so please feel free to correct me if I’m wrong.