Vapor distillation
Thread Content
I am seeking an experimental setup for steam distillation of o-nitrotoluene. When using such a setup for pilot tests in the laboratory, it was found that the amount of steam generated was too low to allow for effective recovery of o-nitrotoluene. I am looking for a better experimental setup; a pilot-scale setup would also be acceptable
This device looks very high-end. What is the principle behind a vapor generator? How is the 5# vapor inlet pipe connected? Is it because the amount of steam added is insufficient, there isn’t enough heat source, or the insulation is inadequate, which prevents the material from vaporizing?
Induction cooker + pressure cooker, to replace Device No. 1
Water is added directly to the material, and the heating jacket is used to raise the temperature of the entire material