The lining of the inner and outer walls of the regenerator riser pipe fell off
Thread Content
What is the reason for the lining of the inner and outer walls of the regenerator riser to fall off? Our device is a high-low parallel type, the regenerator is completely regenerated, and the front burning tank is installed.
The lining of the reverse part is constructed with different levels of high-temperature materials and wear-resistant materials. In fact, the temperature rise in each start-up stage is very particular, especially for those newly constructed parts, which require three-stage heating and fixed-point maintenance. If the temperature rises too fast and the constant temperature is too short, it will cause damage due to unsatisfactory dehydration and uneven expansion.
Analyze the reasons! Find the solution!
It is indeed unreasonable to use tubular anchors. If the welding is firm, the insulation material will only fall off. If one end of the flat steel is cut into a herringbone shape, and the other end is bent at a right angle and welded, the anchoring effect should be better than this. The key issue is welding.